The cocoa Countryman E6 Omnidirectional Earset Mic, Medium Gain with Detachable 2mm Cable and TA4F Connector for Shure Wireless Transmitters is a vocal microphone with an adjustable boom that weighs less than one tenth of an ounce and is designed to be used by only one person. Once adjusted, it will continually hold this shape.

The E6 earset can be used on either ear for capturing audio and rejecting unwanted sound, feedback, or surrounding noise from stage monitors or nearby speakers in houses of worship, theater, and outdoor vocal and speech applications.

The low-profile, omnidirectional E6 earset virtually disappears against the skin, so performers will forget they're wearing a mic. This version offers medium gain for very loud speaking, such as in theater performances and most vocals. In addition, the earset comes with three protective caps with different high-frequency response characteristics that control the amount of crispness or sibilance (response at 15 kHz). This omnidirectional E6 earset's cable terminates to a TA4F connector for direct connection to Shure AD1, ADX1, AXT100TA4F, GLXD1, PGXD1, QLXD1, and ULXD1 wireless bodypack transmitters.

For Stage, Theater, and Broadcast TV    Fits Shure Transmitters    Headroom for Speaking and Vocals    Detachable 2mm Diameter Cable    Stiff, Steel Boom    Includes Windscreen    3 x Protective Caps    Black and White Single Tie Cable Clips    Carrying Case

The Countryman earsets are very small, lightweight, and the least visible headworn microphones.

The classic E6 is a good choice when one person will wear the microphone. Because the boom is stiffer, it can be adjusted to fit, then stored away and quickly reworn.

The E6's stainless steel boom is tough and can be bent and re-bent to fit different performers. It is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps. The earset should always have a protective cap in place to keep sweat, makeup, and other foreign material out of the microphone.

The E6 earset's flexible boom is easily shaped right on the performer's face. Changeable protective caps let you shape the frequency response for different situations or to match other microphones. This omnidirectional version includes three protective caps—+4 dB (bright), +8 dB (very bright) and +0 dB (flat)—that controls the amount of crispness or sibilance (response at 15 kHz.)

Easy adjustment keeps the mic in a comfortable position for rejecting unwanted sounds. The omnidirectional E6 earset provides more isolation and is suitable for situations where there are loud monitors, extreme feedback, or environmental noise.

The included removable, quick-swap cable detaches from the actual earset, making it completely replaceable in the event of a short or break. The replaceable cable design makes upgrading wireless microphone systems easy as they are available in a wide selection of connections to accommodate most wireless transmitters.

Related Questions and Answers

Q: 1. Does this work with QLXD transmitters ?

A: Yes, the Shure SB900B is the compatible rechargeable battery pack for use with the QLXD series wireless transmitters.

Q: 2. Does it work with old analog axient?

A: No just the new digital models.

Q: 3. Can this cable be used to connect an mke600 mic to a bmpcc4k camera?

A: No, the Shure C129 Replacement Cable would not facilitate a connection between the Sennheiser MKE 600 Shotgun Microphone and the Blackmagic Design Pocket Cinema Camera 4K. A cable such as the Kondor Blue Mini-XLR Male to XLR Female Audio Cable (BH #KOMXLR16BK) would allow connection between the microphone and camera as desired: https://bhpho.to/3pxTORZ

Q: 4. About how long do the batteries last when they're fully charged?

A: The Shure SB900B Rechargeable Lithium-Ion Battery for Bodypack Transmitters/Receivers has an estimated run time of up to approximately 12 hours when fully charged.

Q: 5. This network port can connect this microphone in Dante protocol?

A: The Ethernet port on the Shure SLXD4 Receiver can be connected to a network switch which can then be connected to a Dante network. However, the Shure ULXD4D Dual-Channel Digital Wireless Receiver and ULXD4Q Quad-Channel Digital Wireless Receiver both feature a Dante dual-port network interface for digital networking capability.

Q: 6. Is there a 6 foot version of this cable available?

A: Unfortunately, the Shure C122 replacement cable is available only in a 4 foot length.

Q: 7. Does this come with charger?

A: The Shure SB900B Rechargeable Lithium-Ion Battery for Bodypack Transmitters/Receivers (BH #SHSB900B) is a single battery only. From the same product page, there is an option for "2-Pack with Dual Bay Charger" (BH #SHSB900BCK (B&H Kit)): https://bhpho.to/3KiD0Xq

Q: 8. What adapter or cable can I use to connect this to a regular 3 pin XLR cable? Thanks

A: This PGA98H-TQG model is wired for connection to a Shure wireless transmitter. Although there is an adapter available, for XLR connection with phantom power, it will usually not be the most cost effective option: (https://www.bhphotovideo.com/c/product/619325-REG/Voice_Technologies_VT0137_VT1126_48V_Phantom_Power.html). Instead, I would recommend purchasing the version of this mic that is already made for a hardwired XLR connection. Our part number for it is SHPGA98HXLR and I am linking it below: https://www.bhphotovideo.com/c/product/1128561-REG/shure_pga98h_xlr_pga_98h_clip_on_cardioid.html

Q: 9. will this fit a sony condenser mic?

A: It might fit your SONY mic if its dimensions are similar to the Shure VP89M Modular Shotgun Microphone B&H # SHVP89M

Q: 10. what cable goes with this?

A: The Shure SM63LB features a male XLR connector. AN XLR mic cable would be used to connect to most devices Such as the Kopul 3000 series cables. Many customers also use these mics with devices such as portable audio recorders and even cameras/camcorders. in this case you would require an adapter as well. The Kopul LMT100 is a popular choice.