Store, transport, and protect your gear from moisture and dust with the yellow 720 Protective Case with Padded Dividers and Mesh Lid Organizer from Seahorse. The case features padded touch-fastening dividers, a mesh lid organizer, an automatic purge system, a latch closure, padlock hasps, an exterior ID window, and a large top handle.

Watertight, Dustproof Case    Padded Dividers and Mesh Lid Organizer    Lock Hasps    Automatic Purge System    Latch Closure    Large Top Handle    Padlock Hasps    Exterior ID Window

Related Questions and Answers

Q: 1. Will this fit a Sony A7iv?

A: No, the foam inside the SKB iSeries 1309 Waterproof Case for Sony A7R IV Camera is a little different in shape to work with the a7r IV. S0, it does not fit the a7IV.

Q: 2. What type of material is the sunscreen made out of?

A: Has like waterproof fabric and 2 L metal brackets inside for them to stay up.

Q: 3. What type of screws are used?

A: The A-MoDe Limited Mesh Lid Organizer for Pelican 1615 Case comes with six (6) M4-sized screws.

Q: 4. Where is this seahorse 630 made? Thanks

A: The country of origin for the Seahorse 630 Protective Case with Metal Keyed Locks (Foam, Black) is the United States.

Q: 5. How is this supposed to attach to an im2500 case? There are no screw receiver holes in an im2500 lid as there are on the 1510.

A: This Mesh Lid Organizer for Pelican 1510/1535/IM2500 Storm Case can be easily installed in your case lid with the included screws.

Q: 6. Is this case submersible?

A: This is watertight and has a IP67 rating. This means the unit can be dropped into a body of water up to a meter deep for half an hour.

Q: 7. Sigma 24-70 Art fit upright in SKB iS1309 as it’s slightly bigger than the Sony 16-35 GM? How much room can lens be above foam?

A: You can fit the Sigma 24-70mm f/2.8 DG DN Art Lens for Sony E without the lenshood in one of the lens pre-cut space of the SKB iSeries 1309 Waterproof Case for Sony A7R IV Camera.

Q: 8. Is it possible to buy this case without the dividers? Just the case, and the lid organizer?

A: You can purchase the empty case and the lid organizer seperately. Click the links below to view the empty case and the organizer; https://bhpho.to/3mFDEmV https://bhpho.to/2RLjKsu

Q: 9. Will this work with the Apache 5800 case from Harbor Freight?

A: The A-MoDe Limited Mesh Lid Organizer for Pelican 1510/1535/IM2500 Storm Case has not been tested with the Harbor Freight Apache 5800 case. The dimensions of the Apache 5800 and the Pelican 1510 Carry-On Case are close, so the lid organizer might work.

Q: 10. Would this case be good with a Nikon D610 with battery drive attached? How would I position the camera properly?

A: The advantage with this case is the lenses can be transported vertically and thus you can get more long lenses in one case. Regarding the D610 with grip, it is about 6.5 tall. Since the case is 9 deep, I would suggest adding 2-3 of foam to the compartment for the camera/grip so you can place it base down. Then it will not be jostled. I suggest a similar action for the other compartments if needed.