This Global Truss Small Caster for ST-180 Crank Stand is a replacement for one of the casters that comes with the crank stand.

Replacement Caster

Related Questions and Answers

Q: 1. could the lift be modified to a height of 32 feet?

A: According to the manufacturer, the maximum height of this stand is 18 feet and it cannot be modified.

Q: 2. I have a calumet mf6090 light stand. I need a replacement knob. Its his the knob to buy?

A: This knob has not been tested with your specific stand. Your results may vary.

Q: 3. At other websites, the DT-3800L specs state that there is a minimum load requirement of 22 lbs. What happens if the load is less than 22 lbs? Is this minimum required to ensure that the automatic braking works properly?

A: The stands requires a load to ensure that the break works properly. If the load is less than 22LBS nothing negatively will happen. The stand simply requires an load other than the weight of it's own telescoping module.

Q: 4. Could this sopport cine lights?

A: The Global Truss ST-180 Extra Heavy-Duty Crank Stand with Outriggers can support lights that are mounted to a truss section suspended between two of these stands. For a single light, you may wish to consider the Avenger Wind Up Stand 26 with Braked Wheels (Chrome-plated, 8.5'), BH # AVB6026CS. https://bhpho.to/3EfgDlL

Q: 5. can you tell me the specs on this? MFR #SQ-C9-45 • BH #GLSQC945

A: Please contact Global truss customer service for product specs and support. Tel: 323-415-6225

Q: 6. What is the outside dimension of the pole which inserts into the square column?

A: I just received the stand and was able to make measurements. I concur that the OD of end of the pole which inserts into the column is 1-1/16". The other end includes a larger 6" long section with a outside diameter of 1-3/8". This is the end where you would attach other devices. 1-3/16" is a standard size for light stands and speaker stands. There are also adapters available at B

Q: 7. Does this product have a m12 thread or similar on top to be used with lighting clamps?

A: The stand does not have any threads to receive a clamp.

Q: 8. What is the distance from the handle in its lowest position and the bottom of the column?

A: 48-3/4"

Q: 9. Can I add wheels to the stand?

A: No. Wheels can be added to the following unit.

Q: 10. What is the diameter of the top pole, 1 3/8 or 1 1/2?

A: The diameter of the top pole is 1 3/8