Exclusive to B&H, this SKB iSeries Waterproof Case is designed to safely store and transport a Sony UWP-D two-channel wireless combo mic system. It features a custom-cut PE foam interior that securely holds one URX-P03D two-channel camera-mount receiver, two UTX-B40 bodypack transmitters, one UTX-P40 plug-on transmitter, and one UTX-M40 handheld transmitter/mic or the handheld mic of your choice. Additional compartments accommodate lavaliers and various small accessories.

The waterproof cases is molded of ultra-high-strength polypropylene copolymer resin. It features a gasket-sealed, water-and-dust-tight, submersible design (MIL-C-4150J / IP67), which is resistant to UV, solvents, corrosion, fungus, and impact damage (MIL-STD-810G).

Other features include a molded-in hinge, a patented trigger-release latch system, a comfortable, snap-down, rubber-over-molded-cushion grip handle, and an automatic ambient-pressure equalization valve (MIL-STD-648C).

Made in the USA, the case comes with a limited lifetime warranty.

Fits One URX-P03D Dual-Channel Receiver    Fits Two UTX-B40 Bodypack Transmitters    Fits UTX-P40 Plug-On & UTX-M40 Handheld    Accommodates Lav & Accessories    Military Polypropylene Exterior    Gasket Seal for Watertight Rating    Ambient Pressure-Equalization Valve    Trigger Release Latch & Molded-In Hinge    Stainless Steel Locking Loops    Rubber Over-Molded Cushion Grip Handle

Related Questions and Answers

Q: 1. Can you run this on USB without batteries installed?

A: Yes, the Sony UTX-P40 Wireless Plug-On Transmitter can be powered through its USB port, instead of using batteries.

Q: 2. Is this unit compatible with the new URX-P41D wireless receiver?

A: Yes the Sony UTX-P40 is compatible with the URX-P41D receiver in the same frequency band.

Q: 3. What is the expected battery life when using Phantom Power?

A: When using the Sony UTX-P40 Wireless Plug-On Transmitter with two standard AA size alkaline batteries and output power is set for 30 or 40mW and phantom power is on, the estimated battery life is approximately 6 hours. With phantom power turned off, the estimated battery life is approximately 8 hours when set for 30mW of output power and approximately 7 hours when output power is set for 40mW.

Q: 4. Will this work with utx-b03 and urx-p03? Thanks in advance

A: Yes, the Sony BLC-BP2 UWP Belt Clips for Select UTX and URX Series Components will work with both UTX-B03 and URX-P03 units.

Q: 5. Is this compatible with the URX-P03D (stereo) receiver?

A: Yes,as lomg as both are in the same frequency bank and tuned to the same frequency.

Q: 6. Is UTX PO3 compatible with urx po3d?

A: Yes, the Sony UTX-P40 Wireless Plug-On Transmitter is compatible for use with the Sony URX-P03D Dual-Channel Camera-Mount Wireless Receiver, however, both devices must operate within the same frequency band.

Q: 7. Can this clip fit the Sony UWP-D11?

A: Yes they will

Q: 8. Can this mic be used with the UWP-D11 receivers? And more specifically, can they sync channels with the IR feature found on the side of the UWP D11 receiver pack?

A: Yes, this mic can be used with a receiver from the UWP-D11 system. There is an IR sensor on the bottom of the mic to allow for IR syncing. Please note, the transmitter frequency range must match that of the receiver.

Q: 9. Is this capsule compatible? https://www.bhphotovideo.com/c/product/341229-REG/Shure_RPW112_RPW112_Dynamic_Replacement_Element.html

A: Yes, the UTX-M transmitters, including the UTX-M40 wireless handheld transmitter, are compatible with mic capsules designed for Shure wireless transmitters. The RPW112 SM58 unit you asked about will work.

Q: 10. Does this BLC-BP2 clip is the original replacement for UTX-B40 and URX-P40 (with the plastic hotshoe plate)?

A: Yes, the Sony BLC-BP2 UWP Belt Clips for UTX-B03, UTX-B03HR, URX-P03, and URX-P03D are compatible for use with Sony UTX-B40 Wireless Bodypack Transmitter and the URX-P40 Camera-Mount Wireless Receiver.