The white Canare Starquad Unisex XLR-TRSM Cable (6') is handcrafted with the super flexible Canare L-4E6S cable and superior Neutrik XLR and TRS Phone connectors. Use Starquad for reduced hum and EMI, and no handling noise. This cable is perfect for all microphone use and great for connecting balanced output of some audio processors, mixers, and low density patch bays to XLR inputs.

Special cross-linked PE insulation

Hand assembly with true silver solder

Pure performance Neutrik XLR and Neutrik Phone connectors

Related Questions and Answers

Q: 1. How long is it from the end of the banana plug to the jacket? In other words how long are the exposed red and black wires? Thanks.

A: 6 inches.

Q: 2. Is this for one single cable, or a stereo pair?

A: The Canare 4S11 speaker cable can be used for applications with bi-wire and bi-amp configurations where the amplifier has two sets of outputs and the speaker has two sets of inputs which are typically stereo pairs.

Q: 3. From the picture it looks like there are 2 red and 2 black for the flex braid. How is it distinguish which wire is which from one end to the other?

A: Now I understand your question, no, there are no marking for the pairs, I used a voltmeter to determine the pairs, then labeled it myself.

Q: 4. Is there a way to tell the difference between the 2 groups of wiring on each end?

A: There should be markings on each set of connectors that allow you to differentiate between the two different groups on the Canare 4S11 Speaker Cable with 4 Banana to 4 Banana Connectors.

Q: 5. Is the length from the Y ? I am looking to put two mics on a single incoming line, 6 feet apart. Will this work?

A: The Kopul XLR Y Cable (XLR-M to Dual XLR-F) is 15" long overall. The manufacturer has not provided a distinction for length either before or after the split, but the Y-junction is approximately halfway down the cable's length.

Q: 6. What’s the inside dimension of the spade?

A: The inside dimension of the spade on the Canare 4S11 Speaker Cable 2 Banana to 2 Spade (3') is 2.5mm .

Q: 7. If I combine two mics and plug into a tascam recorder single port, will I still be able to deliver phantom power to the two mic?

A: Connecting two condenser microphones to one mic preamp with the Kopul XLR Y Cable is not recommended. It may work, but it may also result in undervolting the mics, which will lead to undesirable results.

Q: 8. Is this a single speaker cable?

A: Yes the Canare 4S11 is a single 2 Banana to 2 Spade cable.

Q: 9. This is a pair or just one cable for one speaker only?

A: This is one cable with four banana connections on each side.

Q: 10. Does anyone know what the length of the banana plug is? Clearance is tight between the back of my amplifier and the rear of the av cabinet, and these look like long connectors. I may have to go spade to be safe.

A: According to Canare they are #PIN1 pins (.077" wide x .113" high).