The yellow Canare Starquad Unisex XLR-TRSM Cable (3') is handcrafted with the super flexible Canare L-4E6S cable and superior Neutrik XLR and TRS Phone connectors. Use Starquad for reduced hum and EMI, and no handling noise. This cable is perfect for all microphone use and great for connecting balanced output of some audio processors, mixers, and low density patch bays to XLR inputs.

Special cross-linked PE insulation

Hand assembly with true silver solder

Pure performance Neutrik XLR and Neutrik Phone connectors

Related Questions and Answers

Q: 1. How long is it from the end of the banana plug to the jacket? In other words how long are the exposed red and black wires? Thanks.

A: 6 inches.

Q: 2. How does one handle phantom power when splitting the signal into 2 inputs? Would you enable phantom power on both inputs or just one of the two to power a Sennheiser MKH 50? I would like to feed my boom dialog mic into 2 inputs on a Zoom H6, and run one input hot and the other about 10 db less for safety. I know the Zoom offers a back up file record, but it is only on the non phantom powered inputs.

A: As long as the mic gets phantom power it will be powered, functional & able to send signal to whereever you route it. Therefore you only need to power it from ONE channel. There is No need to send phantom on both channels.

Q: 3. Is there a way to tell the difference between the 2 groups of wiring on each end?

A: There should be markings on each set of connectors that allow you to differentiate between the two different groups on the Canare 4S11 Speaker Cable with 4 Banana to 4 Banana Connectors.

Q: 4. If I combine two mics and plug into a tascam recorder single port, will I still be able to deliver phantom power to the two mic?

A: Connecting two condenser microphones to one mic preamp with the Kopul XLR Y Cable is not recommended. It may work, but it may also result in undervolting the mics, which will lead to undesirable results.

Q: 5. is this price for the 300 meters ?

A: Yes. This product is a 984.25 foot coax cable (299.9994 meters) .

Q: 6. Is it possible to use these cable from 2 input of an amplifier to one output of an active filter ? ( merge 2 miss speaker to one output mid of my x-over ? )

A: Yes you can!

Q: 7. Is this a single speaker cable?

A: Yes the Canare 4S11 is a single 2 Banana to 2 Spade cable.

Q: 8. what size spade connector?

A: It is 4mm.

Q: 9. This is a pair or just one cable for one speaker only?

A: This is one cable with four banana connections on each side.

Q: 10. Is the length from the Y ? I am looking to put two mics on a single incoming line, 6 feet apart. Will this work?

A: The Kopul XLR Y Cable (XLR-M to Dual XLR-F) is 15" long overall. The manufacturer has not provided a distinction for length either before or after the split, but the Y-junction is approximately halfway down the cable's length.