Run your 1/4" TRS cable through the wall neatly with the white Lexan My Custom Shop 1/4" TRS Wall Plate. It features a female 1/4" TRS connector on each side, so you can run your cable through the wall for easy connection to your compatible devices.

Single-Gang Design    Female 1/4" TRS Ports on Front and Rear

Related Questions and Answers

Q: 1. Will this receive a full size C-stand riser?

A: Yes, the opening is 1 1/8 which is standard for most C stand columns.

Q: 2. Can the handle be removed?

A: Yes the handle can be unscrewed.

Q: 3. Can this be mounted on a standard light stand?

A: This Impact Wall Plate can only mount to a wall or ceiling and would accept a junior pin on top.

Q: 4. What diameter are the screw holes, and how far apart are the holes from each other?

A: According to the manufacturer you can use 6d or 8d nails, or drywall screws. They do not have a measurement for the spacing.

Q: 5. can it be ceiling mounted?

A: As long as you have adequate support from above yes. I would look to anchor all four of the bolt holes into something very solid like a floor joist from the floor above. Be careful about finding a mounting surface that will provide adequate width so that you anchor all 4 corners using the provided holes. I would not bolt this to a drywall ceiling and attach anything weighing more than a few pounds to it. If you bolt this to the ceiling then you should also consider what you are going to attach to the pin and ensure that you can grip that pin firmly enough that it can hang upside-down with all of the weight trying to pull away form the pin.

Q: 6. Can this also be used as a junior pin?

A: Remove the screw and it should fit a junior receiver.

Q: 7. Does it work with an Echo vis Bluetooth?

A: The Vanco PulseAudio PA230WP is not compatible with an Amazon Echo. It is made to sync via bluetooth to a smartphone or tablet to play that media through an amplifier that the Vanco PulseAudio PA230WP would be wired to.

Q: 8. Hi, I recently purchased from B&H the HLPP3M loupe and now want the base plate to suit my 800e ... Is this the correct one and will it work with and without the battery base on the camera? ..thanks Geoff (a wish I lived in New York customer so I could see all the goodies in the store)

A: Yes, the Hoodman HCP DSLR Camera Custom Finder Base would be compatible for use with the Nikon D800E DSLR camera both when using the camera with a battery grip or when used with the camera by itself.

Q: 9. Hi, is this compatible with a Canon 250D? Thank you!

A: The Hoodman HCP DSLR Camera Custom Finder Base Plate for HoodLoupe is made to be a universal DSLR solution and should work fine with a Canon 250D.

Q: 10. Does it come with a power supply? If yes, do you have a picture?

A: Yes it comes with a power supply. It listed in the 'In The Box' section of the product page on your far right-hand side of the Overview Tab. We do not have a picture of it.