The Pivot Shoulder Bolt Kit from Ready Rig can be used as replacements or spares for your Ready Rig GS series vest. This kit includes two shoulder bolts.

2 x Pivot Shoulder Bolt Sets    For All Ready Rig GS Series Vests    Use as Replacements or Spares

Ready Rig GS VEGA

Ready Rig GS + ProArms

Ready Rig GS

Related Questions and Answers

Q: 1. Would this shoulder mount work for a Blackmagic Ursa? Or is that too heavy/large for it?

A: Yes the PolarPro Pivot Shoulder Rig System can support a Blackmgic URSA.

Q: 2. Can this rig hold a canon c500 mark ii (or c300 mark iii)? with cinema lenses. Mostly for documentary use.

A: Yes, The Canon C500 II or Canon C300 mk II would be supported when using the PolarPro Pivot Shoulder Rig System.

Q: 3. Will this work for handheld operation? Also would it work with the Letus Helix Pro gimbal?

A: The Ready Rig GS Stabilizer + ProArm Kit with Case can be use for handled shooting when using proper mounting solutions. The Ready Rig GS Stabilizer + ProArm Kit with Case should als be able to support the Letus35 Letus Helix Pro Magnesium Gimbal, but it may be difficult to operate the gimbal, again it would depend on how you mount the gimab to the straps.

Q: 4. What is the weight capacity for this unit? Could it support a moderately setup DSMC2?

A: Polar Pro does not provide a supported weight. However it would support RED DSMC2 setups in the 10-17lb range.

Q: 5. Can you upgrade to the GS arms later?

A: You are in luck, yes, the original GS can be upgraded with ProArms at a later time.

Q: 6. Can the pins that adjust the back support be replaced? One of the back pins appears to have fallen off and I can no longer adjust the back support

A: BH #RERRHRK is the Ready Rig Hardware Replacement Kit.

Q: 7. Will this work with the DJI ronin 2?

A: Yes, if you keep the overall load of the Ronin 2 with camera at or below 30 pounds. The Ronin 2, B&H # DJRONIN2, weighs about 12 pounds and has a 30 pound load capacity. If the total of the Ronin 2 and camera goes over the 30 pound mark, you will need to look in to the Pro Arm Model, B&H # RERIGGSA, which has a 40 pound load capacity.https://bhpho.to/2CSe72b

Q: 8. Is this compatible with the Movi Pro with an Alexa Mini configuration? if it is, do I need to add some accessory? or i can mount it just out of the box?

A: This product has strong velcro straps which you'd connect directly to the handles of the Movi Pro. It also has a total load capacity of 30 pounds, just as long as your rig is below that it will work. If it goes over 30 pounds you will need to step up to BH #RERIGGSA which has a 40 pound capacity.

Q: 9. Rod spacing is not specified, But i stool want to know, is it 60mm? (15mm LWS Standard)

A: The PolarPro Pivot Shoulder Rig System follows the 15mm LWS(Light Weight Support) industry standard. The rods are 60mm apart on center.

Q: 10. Does the Manfrotto 502 plate work with this?

A: Regarding the PolarPro Pivot Shoulder Rig System, there is no mention of the plate being compatible or being a Manfrotto style plate.