Run your DVI cable through the wall neatly with the ivory Lexan My Custom Shop DVI Wall Plate. It features a DVI connector on each side, so you can run your cable through the wall for easy connection to your display or source device.

Single-Gang Design    DVI Port on Front and Rear

Related Questions and Answers

Q: 1. Will this base plate work with the Fuji XT-2?

A: Yes, the Hoodman HCP2 Mirrorless Camera Custom Finder Base Plate for HoodLoupe is compatible with the Fuji XT2.

Q: 2. What size screws do the front port holes use for adapators? I bought TecNec SCREW-38B 4-40 x 3/8" Flat Heads, but they too small

A: The My Custom Shop 16-Port Unloaded Rackmount Panel with Rear Lacing Bar (1 RU) does not have threaded mounting holes, so you will need to use a nut with your screws. The recommended screw is SCREW-38B and the corresponding nut would be the NUT-CMT.

Q: 3. Will this fit a matthews BabySitt'r?

A: No, the base plate of the Matthews Junior Wall Plate is too large to fit into the Matthews BabySitt'r.

Q: 4. Is there a writing area in each page?

A: Yes, on the inside closest to the bindings.

Q: 5. How much is the load capacity?

A: This question cannot be answered without knowing the direction of the load and the orientation of the base to which the load is applied. Oriented where the contained rod is vertical and in compression, failure would occur in the rod. Oriented where the rod is vertical and in tension would result in the failure at the set screw where the rod is attached to the base where the rod is steel or in the rod if it is aluminum.Oriented where the rod is horizontal would result in a bent rod long before this base would fail if it is firmly attached to a wall. I think the screws holding the base would fail before the base. This base is steel and is not likely to fail.This base accepts a 16mm rod. I think even a steel rod would bend before this base would bend or a weld would break.This base accepts a 16mm rod.

Q: 6. Will it mount to a Sony FX3?

A: Yes, the Hoodman HCP2 Mirrorless Camera Custom Finder Base Plate for HoodLoupe would work with the SONY FX3. Please note that this is just the mount, and it does not include the Hoodloupe. The best choice would be the 3.0" model but that is discontinued. Hoodman HoodLoupe Outdoor LCD Viewfinder for 3.2" Screens BH #HOH32MB • MFR #H32MB

Q: 7. Can the handle be removed?

A: Yes the handle can be unscrewed.

Q: 8. can this be used to mount viewfinder for Nikon d800 on a rig?

A: This will support our Hoodloupe HLPP3M and it will work with a Nikon D800.Rig? It depends which one. Send me a photo.Thanks,Bob

Q: 9. Will this work with the Sony Fx3?

A: Yes, the Hoodman HCP DSLR Camera Custom Finder Base Plate for HoodLoupe can work with the FX3.

Q: 10. What is the size of the screw holes?

A: The scroll holes measure about 6mm.