Run your audio, video, data, or power cables through the wall neatly with the white Lexan My Custom Shop 0.75" Grommet Wall Plate. The grommet allows the pass-through of any cables up to a total diameter of 0.75" for easy connection to your devices.

Single-Gang Design    0.75" Pass-Through Grommet

Related Questions and Answers

Q: 1. How much is the load capacity?

A: This question cannot be answered without knowing the direction of the load and the orientation of the base to which the load is applied. Oriented where the contained rod is vertical and in compression, failure would occur in the rod. Oriented where the rod is vertical and in tension would result in the failure at the set screw where the rod is attached to the base where the rod is steel or in the rod if it is aluminum.Oriented where the rod is horizontal would result in a bent rod long before this base would fail if it is firmly attached to a wall. I think the screws holding the base would fail before the base. This base is steel and is not likely to fail.This base accepts a 16mm rod. I think even a steel rod would bend before this base would bend or a weld would break.This base accepts a 16mm rod.

Q: 2. Does it work with an Echo vis Bluetooth?

A: The Vanco PulseAudio PA230WP is not compatible with an Amazon Echo. It is made to sync via bluetooth to a smartphone or tablet to play that media through an amplifier that the Vanco PulseAudio PA230WP would be wired to.

Q: 3. Hi, I recently purchased from B&H the HLPP3M loupe and now want the base plate to suit my 800e ... Is this the correct one and will it work with and without the battery base on the camera? ..thanks Geoff (a wish I lived in New York customer so I could see all the goodies in the store)

A: Yes, the Hoodman HCP DSLR Camera Custom Finder Base would be compatible for use with the Nikon D800E DSLR camera both when using the camera with a battery grip or when used with the camera by itself.

Q: 4. can this mount the Blackmagic Micro Converters?

A: Yes, you can use the BLACKRACK-2 Universal Mini Converter Rackmount to mount the Blackmagic Design Micro Converters.

Q: 5. Will this fit Lumix ZS100?

A: Yes, this will work on the ZS100. It has a 1/4"-20 threaded hole on the bottom of the camera so you can screw in Jobu Design Quick Release Plate.

Q: 6. Hi, is this compatible with a Canon 250D? Thank you!

A: The Hoodman HCP DSLR Camera Custom Finder Base Plate for HoodLoupe is made to be a universal DSLR solution and should work fine with a Canon 250D.

Q: 7. What size screws do the front port holes use for adapators? I bought TecNec SCREW-38B 4-40 x 3/8" Flat Heads, but they too small

A: The My Custom Shop 16-Port Unloaded Rackmount Panel with Rear Lacing Bar (1 RU) does not have threaded mounting holes, so you will need to use a nut with your screws. The recommended screw is SCREW-38B and the corresponding nut would be the NUT-CMT.

Q: 8. Can this support the Nova P600c weight? I want to mount the P600c to my wall or ceiling but not sure if it's too heavy.

A: The type of wall and how you anchor the Avenger F300 Junior Wall Plate (Chrome-plated) BH #AVF300 will determine the load it can support.

Q: 9. What are dimensions of the base?

A: 5.9 x 3.6 inches

Q: 10. Will this base plate work with the Fuji XT-2?

A: Yes, the Hoodman HCP2 Mirrorless Camera Custom Finder Base Plate for HoodLoupe is compatible with the Fuji XT2.