This 12-pack of black Finishing Caps for EMBRACE Earmounts from Point Source Audio is designed to provide a neat finishing cap for the earmount when it is trimmed and customized for over-ear concealment. These finishing caps will fit any EMBRACE earmount.

For EMBRACE Earmount Microphones    Use for Customized Over-Ear Concealment    Provides Neat End for Trimmed Earpiece    Fits Any EMBRACE Earmount

Related Questions and Answers

Q: 1. Would this light source cover both 35mm and 6X6?

A: Yes the Negative Supply Light Source Mini will scan 6x6cm negatives which is 2 1/4 Inch negatives. The scanning area is 3.75 x 2.5"

Q: 2. Can you use this with Color C41 film?

A: The Ilford Simplicity Black and White Film Wetting Agent is not compatible with C41 film.

Q: 3. Can we reuse the fixer? For up to how many rolls?

A: A general rule-of-thumb would require you to test your fixer working solution immediately after mixing to find its clearing time, then when it takes twice as long as the original test to clear the film, you may discard it. In practice, to test your working solution, you can take an unexposed piece of film (such as the film leader) and place a drop of fixer on the emulsion side of the film. Leave it for approximately 20-30 seconds. Then place the film into the fixer, ensuring it is covered. Time how long it takes for the clear spot to disappear (when you can no longer tell the spot you placed the drop of fixer from the rest of the completely clear film). This would be the fixer's clearing time. You would double this time amount to find the amount of time it takes to fix your film (i.e., if it took 2 minutes 10 seconds for the film to become completely clear and the dot to disappear, you would fix film for 4 minutes 20 seconds). You would test your fixer every time before using the fixer. When, during your test, it takes twice as long to fix your scrap film leader to clear as it did when you first mixed the working solution, it may be discarded and you may make a new working solution. (if you wish, you may wait until it takes triple the time your original test took to clear, but this would result in extremely long fixing times).

Q: 4. Can you use these as windscreens?

A: bought

Q: 5. Is it working fine as a karaoke amplifier?

A: You could use this to plug your microphones into it and then send the signal out to something else.

Q: 6. Does this light come with a stage pin power connection option?

A: The ETC Source Four PARNel stage pin connection model is no longer available.

Q: 7. What is the diameter of the hole?

A: The manufacture does not list the diameter of the hole for the Platypod Heavy-Duty Rubber Caps (4-Pack). It is made specific for the opposite end of a spiked foot on the Platypod. The return policy is 30 days. The link for that is, https://bhpho.to/2bxrYlG.

Q: 8. what is development time for HP5?

A: 6:30 at 68 degrees 5:30 at 75 degrees

Q: 9. What happens if you develop 2 35mm and then reuse it to develop 2 more?

A: The results could be less than ideal such as under developed and lower contrast negatives.

Q: 10. Can this be used for prints as well?

A: The SIMPLICITY Stop Bath from Ilford is a pre-measured portion of ILFOSTOP liquid concentrate stop bath, delivered in a single-use sachet, which is enough to process exactly one roll of 120 or two rolls of 35mm film in a two-reel, 600mL developing tank. While the stop bath may work for RC paper, I would not recommend it as there is not enough for multiple printing needs.