The Laird HDBNC4855 Series of low profile coax HD-BNC cables are designed for transmitting high resolution uncompressed 12G-SDI / 4K UHD video signals. Ideal for high density jackfields, routers and signal distribution systems where RF performance is critical.

75-Ohm Mini-RG59 Coax Cable    Designed for UHD 4K 12G Video Transport    Compatible with Single-Link Devices

Related Questions and Answers

Q: 1. Is the XLR terminal a MINI?...can it be used in the blackagic pocket 6K camera?

A: Hi Angel. It is a mini XLR Male, I apologize that that info was missing. As far as using this with a Blackmagic Pocket 6K, we can't say for sure- these were designed for RED Cameras, however if the pinout is similar on the Blackmagic camera then this should work. Thanks!

Q: 2. can I add two more mesh points to the same router?

A: This AMPLIFI AFi-HD AmpliFi High Density Router includes two Mesh Points and you can add more if needed.

Q: 3. We have a 5600 sq ft home on 2 levels in the country. We use Verizon 4G Internet, will extenders work in basement w/ 6in wall?

A: Connection strength of the AMPLIFI AFi-HD High Density Router with 2 Rotating MeshPoints can vary depending on the floor plan, construction, and location of the extender, but in most cases the extenders will work in a basement.

Q: 4. Will this still work with 3g or 6g sdi cable?

A: Yes, the Canare BCJ-JRK BNC to BNC Stand-Off Receptacle for 12G-SDI Installations can be used for 3G/6G, but is ideal with 12G-SDI solutions. As stated by the manufacturer: DC to 3GHz - 26dB Return Loss DC to 6GHz - 20dB Return Loss DC to 12GHz - 15dB Return Loss

Q: 5. Can you daisy chain the mesh points to extend the wifi from the router to another building?

A: Depending if the buildings are extremely close this can be possible. However if you are sending it a considerable distance a Point to Point system from Ubiquiti might perform better.

Q: 6. My house is 4 levels and over 6000 sq feet will this be enough or will I need more plug in extenders?

A: It should be adequate, especially if you have ability to put router on a middle level and mesh points above and below.

Q: 7. For clarification: The box MUST ethernet to current internet service?

A: Yes, the AMPLIFI AFi-HD High Density Router with 2 Rotating MeshPoints base station must be connected to your internet service via Ethernet.

Q: 8. how does the router interface with existing router from my internet provider?

A: I currently use a Comcast router. I went into the Comcast router and set it to bridge mode. I then connect the Amplifi router from the WAN port on the Amplifi to one of the ports on Comcast router. I then configed all of my router settings and wifi via the Amplify unit.

Q: 9. Can I create an ad how network? I.E. create a local network without it requiring an internet connection?

A: Hi, not sure if u can because we u do the first time installation is looking for the network connection

Q: 10. How flexible is this cable compared to something like the ZILR 12G-SDI BNC cable?

A: The Kondor Blue 12G-SDI Cable for 4K60 Camera Monitors and Transmitters (Black, 20") is less flexible than the ZILR 12G-SDI BNC Cable (17.7").