The black oak, grass texture Salamander Designs Chameleon Collection Chicago 237S EPS Cabinet with black solid surface top features a simple installation for your Epson LS500 projector with no need to open the wall or ceiling to run cables. All your supporting components can be enclosed in the credenza to provide a beautiful and simple solution.

For Use with the Epson LS500 Projector    Recessed Projector Design    Pinch-Out Rear Panels for Quick Access    Extruded Aluminum Frame

• Flush top surface, recessed projector cavity design
• Extruded aluminum frame creates a support skeleton
• Pinch-out rear panels to permit fast, easy access to components and wiring
• Variety of bolt-on options and accessories are available

Related Questions and Answers

Q: 1. Will this hold a DSLR with an L-bracket attached?

A: As long as it's not a Nikon D6 or Canon 1DX body, something like a Nikon d850 body with a bracket will fit.

Q: 2. Will it fit a Nikon Z6 II with 24-120mm lens?

A: Yes, it will fit with no problem.

Q: 3. Can I put the W 16 x H 13 x D 21cm size equipment in this bag?

A: Interior dimensions are 12 x 20 x 13 cm, so based on your item's dimensions it seems it would have trouble fitting in.

Q: 4. Can I put a7R IV(slightly thicker L-plate attached) and a Zeiss Vario-Tessar 16-35 f/4 lens in this bag?

A: Yes, the A7R4 and the 16-35mm lens will fit.

Q: 5. Is there a way to calibrate the humidity and/or temperature settings on the display? I have used a digital thermometer humidity gauge and an alcohol thermometer to check both: the humidity setting appears to be -5% off (35% instead of 40%, the recommended setting for lenses) and the temp is +3 F off. Too much of a +/- error for my taste.

A: I did not see any calibration instructions in the manual. The temperature in my house is 76 degrees on my thermostat and a digital thermometer. The display on my cabinet says 78 degrees and I have the AC vent closed to that room so I would expect a 2 degree difference. I have my cabinet set at 35% humidity. I live in Minnesota so it's not like our weather is wet like in Florida or dry as in Arizona. However, over the last week we had dewpoints in the high 70's and temps in the 94+ range so it's been tropical to say the least. I use my cabinet for humidity control and for storage as a clean room and only take out the gear I need rather than keeping everything in my bag. If you are sure your testing devices are accurate you can simply make the conversion and set the cabinet accordingly. The price is right for this cabinet.

Q: 6. The interior bottom can be expanded to allow longer lengths. How many inches long is THIS extended length?

A: The extended length is approximately 13".

Q: 7. Can I put Canon R5 with Rf100-500mm Lens?

A: No, the camera and lens combo is too long for the case. You would need a case that is at least 12" long.

Q: 8. What does this mean: Flexibility of infinite vertical adjustment? Can height between shelves be adjusted?

A: It looks like this unit is modulor and one can add or remove shelves as one wishes, it also looks like the height between shelves can be adjusted using the threaded rods according to Salamander,

Q: 9. What is the inner depth of the Shimoda Top Loader when it is fully extended?

A: The Shimoda Designs Top Loader has a depth of 9.5" / 29 cm, when fully extended.

Q: 10. Will this fit a fujifilm 150-600mm lens with xt4 camera attached?

A: No, the Shimoda Top Loader will not fit the combination of Fujifilm X-T4 and 150-600mm f/5.6-8 R LM OIS WR lens.