This Junior to Baby C-Stand Adapter from Rotolight allows lighting fixtures that come with a Junior stud to be mounted on a Baby stand or Baby C-clamps. Constructed with solid steel and chrome plated, this adapter is made up of a 5/8" Baby receiver securely welded to a 1 1/8" Junior receiver, with large knobs for tightening the pins in place.

Adapts Baby Pin to C-Stands    Junior Pin Receiver to Baby Pin Receiver    Solid Metal Construction    Large Knobs

Related Questions and Answers

Q: 1. In the photo featuring the base, what is the black clamp under the top spider that holds the legs?

A: Sorry that the photo creates some confusion, there is no black clamp in this stand, however you may see the part of the leg support that has a protrusion at the place of contact.

Q: 2. I have a space of 128 cm in the trunk of my car that is small. I would like to know if this stand with wheels reaches in that space. According to the specifications says that the length closed is 120 cm but I'm not sure if that includes the wheels or just the column.

A: In transportation mode , I.E. When the stand is collapsed with the wheels folded the total length required to store it would be 133.5 cm. The casters do not come into play because they are attached about 10 cm up the tri-legs. When folded the unit actually stands on the end of the tips of the tri-legs and not on the casters at all. When the unit is in use with the legs extended and resting on the casters, the height from the floor to the top of the collapses stand is 129.5 cm , but I don t think you would be wanting to put it in your trunk this way. In any case all of the measurements are greater than the 128 cm. If the

Q: 3. Do the wheels on this stand lock?

A: Yes, the wheels lock. In fact, locking the wheels also locks the rotation of the caster, so it doesn't even shift from the connection of the caster to the leg.

Q: 4. Can it go the opposite? Junior to baby?

A: Yes, the Impact Baby to Junior Receiver Adapter can be used in either direction.

Q: 5. Can a boom arm be safely added to this stand? If so, which is recommended?

A: Yes it can be used with a boom arm safely.

Q: 6. Is the junior pin the same length as the Avenger adapter? The Avenger adapter is too long to fit in Matthews 4.5 grip heads.

A: I think there are different lengths. Technically the Junior designation is only about the diameter

Q: 7. What is a good travel bag for this stand ?

A: Great question! I ended up trading mine in for a slightly smaller Matthews Baby Jr. Steel Wheeled Stand, so that I could fit it into a Tenba 48 Rolling Tripod/Grip Case. I fill that bag with umbrellas and smaller stands as well and it all fits (but is very heavy). It does have wheels. Good luck!

Q: 8. Does it come with an O-ring?

A: Yes. The following comes with a o-ring.

Q: 9. can the base footprint be adjusted? if I do not want to fully extend the legs?

A: Hi David,The short answer is no. The triangular footprint is designed to provide maximum stability when the legs are fully extended and the 3 wheels are angled correctly to roll smoothly on the floor. When properly set up, the 3 sets of orange coloured support bars should be parallel with the floor. I bought 2 of these from B&H last Fall and I choose them after months of research. They are build to last, very sturdy and heavy but if you need the mount a monolight and softbox securely, these Matthews stands tick all the boxes. Hope this helps, Gerry

Q: 10. What material is the black plating on the steel surfaces?

A: The Matthews Baby Junior Triple Riser Stand (Black, 12.25') BH #MABH386020 is painted.