The cheese-style NATO-Style Handgrip with 1/4"-20 Mounting Threads from Leofoto mounts easily onto the included NATO-style rail on your camera cage or rig to facilitate a low-angle shot, provide side handles, and provide multiple accessory mounts.

In addition to a single-rod clamp, this handle incorporates four shoe mounts and multiple 1/4"-20 accessory threads. The handgrip is made from aluminum and can slide 1.9" side to side and 3.7" forward and back to help balance your camera rig.

Cheese-Style Top Handle    4 x Shoe Mounts, Single Rod Port    Multiple 1/4"-20 Accessory Threads    Slides 1.9" Side to Side on NATO Rail    Slides 3.7" Back and Forth    Durable Aluminum Construction

Related Questions and Answers

Q: 1. What is the maximum weight that the stud can support? i.e. The super clamps say 33 lbs, and the tripod head say 6.6 lbs, but does that mean the stud can support a maximum of 7.6 lbs: 1lb (Weight of 056 3D Junior Pan/Tilt Head) + 6.6lbs (Load capacity of the 056 3D Junior Pan/Tilt Head) = 7.6lbs? I cant seem to find this information anywhere. Thanks!

A: I don't have a specific weight for you, but I regularly use an 8 lb camera setup on the stud at a pretty sharp angle and I have not had any problems. Be careful to not over tighten as the soft brass metal will twist off fairly easily.

Q: 2. Does it have cold shoe mount?

A: The SHILL Smartphone Mount with Two 1/4"-20 Threads BH #SHGP260 does not have a cold shoe mount.

Q: 3. I'd like to try this with a Tascam DR-05 recorder. The recorder is light, but only 2 inches wide. Does this clamp close enough to hold that?

A: David, the clamp doesn't close it will only stretch open. Hope this helps. It is a good adapter for my iPhone 7 Plus.

Q: 4. If not can you recommend one that looks like this with cold shoe? Thanks

A: Here is a similar option with a cold shoe adapter, BH #SHSPTM .

Q: 5. What is the diameter (in mm) of these tubes?

A: Each individual part from the RigWheels 6" Stand-Offs with 1/4"-20 Threads (Set of 4) (B&H# RISO14X64PC) is 6" (about 15.2cm) long and about 2/3" (16.7mm) in diameter.

Q: 6. Will my Avenger D600 boom sit securely on the 3.5" Impact Double Ended Spigot with 5/8" Stud and 1/4"-20 Threads?

A: Yes, the Impact Double Ended Spigot can insert into the stand mount of the Avenger D600 boom, as long as there is a secure connection below it.

Q: 7. Will this allow me to install a light mount, specifically a Godox S2, onto a standard tripod which has a QR plate with 1/4 x 20 threads?

A: Yes.

Q: 8. Does it fit on a tripod?

A: On a tripod head, yes, via the 1/4-20"screw.

Q: 9. Can the 3/8 screw be removed (unscrewed completely) from the rail if needed?

A: The SmallRig NATO Rail with ARRI-Style Accessory Mount ARRI center screw is not designed to be removable.

Q: 10. Is this just for ONE spigot???

A: The Impact Double-Ended Spigot with 5/8" Stud and 1/4"-20 Threads is a single spigot.