Designed specifically to fit their Hybrid 340 cases, the Shell-Case Divider Set consists of one long and four short reinforced dividers with touch-fasteners at each end so you can infinitely reconfigure your case interior to organize, protect, and isolate each piece of gear when you change your kit loadout.

Organize, Isolate & Protect Your Gear    One Long and Four Short Dividers

Related Questions and Answers

Q: 1. Is the 0379 Lid Organizer usable with the 1645 Divider Set for the Pelican 1640 case? Thank you!

A: Yes even with the lid organizer, this divider set will fit and it will fully close and seal no problem!

Q: 2. Does this case work with the Goggles integra and the Goggles 2?

A: Yes, the Go Professional Cases Hard-Shell Case for DJI Goggles & Motion Controller works with the DJI Goggles Integra and the DJI Goggles 2.

Q: 3. Is this water resistant?

A: The Aleon Camera Carry-On Case with Divider Set (Platinum) has a rubber seal to prevent against moisture from entering the case.

Q: 4. Does this case also have room for the goggles? I dont see the spot for it in the photos.

A: Unfortunately no. For a case that also holds the goggles, take a look at the Go Professional Cases Hard-Shell Case for DJI Avata & FPV Goggles.

Q: 5. what is the height of these? its kinda hard to tell just by top down picture and I don't see any secs of the product listed

A: The height of the Shell-Case Divider Kit for Hybrid 550 Cases is approximately 6.8".

Q: 6. What are the actual dimensions of this item? (Specs only give box dimensions)

A: This is designed specifically to fit inside of the Pelican 1650 case. The 1650 case has internal dimensions of 17.5 x 28.6 x 10.7 inches. Which will be the outer dimensions of this part as it will be a perfect fit in to the case. https://bhpho.to/2ImoqQn

Q: 7. will this fit the pelican 1550?

A: Yes it will.

Q: 8. hi, will fit perfect in pelican air 1555?

A: Yes. Designed and made for the Pelican 1555 case.

Q: 9. is there any chance this is fitting in a 1615 air?

A: Pelican Padded Divider Set for 1650 Cases will not fit in the Pelican 1615Air case. The divider set is too large. You need to get the Pelican Padded Divider Set for 1615 Air Case. Here is the link: https://bhpho.to/3pye325

Q: 10. How is the equipment protected at the bottom of the Pelican 1610, after installing these dividers?

A: Primarily its protected by the hard-shell case. The bottom of the insert is is the same thickness as the wall and 2 center dividers.