Combining the best possible cabling, connectors, and construction techniques for world-class performance, the 50' Studio&Stage Speaker Cable from Benchmark delivers the strength and reliability needed for professional studio and stage applications. Sporting 4-pole Neutrik NL4X speakON connectors on each end for dual-channel, bi-amped speaker signals at up to 40 amps, this speaker cable is ideal for demanding applications where minimal crosstalk between speaker pairs is required.

This speaker cable features Canare 4S11 Star-Quad cabling with four heavy-duty 14 AWG stranded conductors. The polyethylene insulation ensures low capacitance and improved frequency response, while the super-flexible exterior jacket allows the cable to retain enough pull and protection for easy installation in any environment. This cable was hand assembled in the USA in Syracuse, NY.

For Bi-Amped Speaker Connections    Carries Two Speaker Channels    Canare 4S11 Star-Quad Cabling    Heavy-Duty 14 AWG Conductors    Super-Flexible Jacket    Polyethylene Insulation    40-Amp Neutrik NL4X SpeakON Connectors    Hand Assembled in Syracuse, NY USA

Related Questions and Answers

Q: 1. how do you adapt this stand to accept clamps?

A: Our speakers just have the pole socket not sure how you would use clamps.

Q: 2. What is the length size from one end to the other 28''

A: The On-Stage SS7920 Dual Mount Speaker Bracket specifies a length of "20 inches from center of one insert".

Q: 3. Will this pole work with the Azden SGM - 1X?

A: This pole includes a standard 5/8 -27 male thread adapter with 3/8 -16 internal threads at the top pf the pole. The Azden microphone includes an integrated Shockmount (Attaches Microphone Stand female threaded 5/8 -27 )

Q: 4. Will this work with Mackie Thump 15 ?

A: I think these are a little light for that size and weight and of course the Sub 15 goes on the floor

Q: 5. I want to use this with Norman stands that have a 5/8 post. Will the screws tighten down to 5/8 ?

A: Yes, the pole will attach to studs.

Q: 6. how much weight is too much for this pole? A 150 ft roll of seamless weighs 100lbs. Will this pole hold that easily?

A: I think that much weight would be a challenge, and is more than I would want to trust for safe and dependable support, especially if it is eight or nine feet above the floor. Whether you are photographing a person or persons, or a product or products, that amount of load on stands and a crossbar is more than I would choose to elevate eight or nine feet.

Q: 7. How much weight can the dual speaker bracket hold?

A: i never had a problem with my two 40lb speakers

Q: 8. diameter of pole for clamping?

A: The very top section is 3/4. the next section down is 7/8, and the bottom section is 1

Q: 9. what batteries are needed?

A: This Benchmark Remote Control Aluminum with Batteries for DAC2/3-Series/DAC1 HDR uses a cr2032 battery.

Q: 10. what is the upper pole diameter?

A: 1.375"