Guitar Amplifier No Sound Output

Ashly Nx3.02 Programmable Output Power Amplifier

Product Code: ga9203
Availability: In Stock

$8,397.00 $12,679.47

Qty

15 reviews Write a review

Description
Reviews (15)

The Ashly NX3.02 Programmable Output Power Amplifier features lightweight, energy efficient Class D switching amplifier technology combined with a switch mode power supply. The NX3.02 amplifier is designed to meet the needs of demanding live sound and fixed installation sound systems in stadiums, arenas, performance venues, worship spaces, and convention centers.

The NX3.02 is a base level amplifier, available in either 2 or 4-channel models. Use rear panel DIP switches to program each channel output for either High-Z (70V or 100V Constant Voltage) or Low-Z (stable down to 2Ω) operation. When in Sleep Mode, the NX3.02 amplifier draws less than 1W.

Parameters
Output Power	Per Channel, EIAJ Test Standard, 1 kHz, 20 Hz to 20 kHz, 1%THD, Low Z Output, All Channels Driven 2 Ω: 3,000 W 4 Ω: 2,000 W 8 Ω: 1,250 W Low Z output, Bridge Mode, 20 Hz to 20 kHz, 1%THD, All Channels Driven 4 Ω: 6,000 W 70 V, 100 V Output, All Channels Driven 70 V (per channel): 2,450 W 100 V (per channel): 1,250 W
Power Draw	Sleep Mode: < 1 W Standby Mode: 40 W Idle (no signal): 55 W
Current Draw	120 VAC Mains (Divide by 2 for 240 V) Sleep Mode: 0.1 A Standby Mode: 0.70 A Idle (no signal): 1.00 A All Channels Driven (Divide by 2 for 240 VAC) Typical: 14.7 A
Dissipation	Thermal (All Channels Driven) Sleep Mode: 3.4 BTU/hr Standby Mode: 136 BTU/hr Idle (no signal): 187 BTU/hr Typical (1/8 maximum power): 1360 BTU/hr
Voltage Gain	Selectable at 26 dB, 32 dB, 38 dB, or 1.4 V
Damping Factor	>250 (8 Ω load <1 kHz)
High-Pass Filter	Input: 80 Hz 2nd order
Distortion	SMPTE (typical): <0.5% THD-N (typical): <0.5% (8 Ω, 10 dB below rated power,20 Hz to 20 kHz)
Channel Separation	-75 dB (dB from full output, 1 kHz)
Signal to Noise Ratio	20 Hz to 20 kHz (unweighted): >114 dB
Frequency Response	20 Hz to 20 kHz, +/-0.05 dB
Input Connector	Balanced: Euroblock 3.5 mm, 1/4" TRS and XLR Combo jack
Input Impedance	10 kΩ
Maximum Input Level	+21 dBu
Output Connector	Speaker: Neutrik speakON
Connection	Data: Euroblock 3.5 mm - Gnd, 18 V, In, Out
Level Control	Remote DC: Euroblock 3.5 mm - Gnd, CV, V+ per input
Attenuation	Per Channel: Front panel, software, offset link group, and remote. Fully off = Mute
Protection	Amplifier: Inrush current limitation, temperature monitoring, output over-power protection, mains fuses
Cooling	Continuously variable temperature controlled axial fan(s)
Environmental	32 to 113˚F (0 to 45˚C) non condensing
Dimensions	19.0 x 3.5 x 16.8" (482.6 x 88.9 x 426.7 mm)
Weight	< 28.0 lb (12.7 kg)
Packaging Info
Package Weight	30 lb
Box Dimensions (LxWxH)	19 x 16 x 4"

2 and 4-channel high-output, lightweight amplifier with programmable output on each channel (Hi-Z or Lo-Z, selected via rear panel DIP switches)

Power-saving, Energy Management System (Ashly EMS) automatic <1W Sleep-mode (defeatable)

Front panel power switch and level controls (can be disabled for security)

Front panel LEDs for temperature, current, signal, clip, mute, bridge mode, protect, sleep, and disable (of front panel controls)

Neutrik Combo XLR - 1/4" TRS jack plus Euroblock input connectors

Neutrik speakON twist locking loudspeaker connectors for security, safety, and reliability

Rear panel DIP switches per channel for selection of high pass filter, limiter, input gain, and High-Z or Low-Z speaker output configuration

Remote DC level control on each input channel

Neutrik powerCON detachable AC mains connector

Switch mode power supply automatically detects 120 or 240VAC operation

Extensive protection circuitry, continuously variable cooling fans

Multiple independent internal power supplies provide increased channel separation and reliability

Related Questions and Answers

Q: 1. Can I hook an equalizer to the Marantz power amplifier?

A: Unfortunately newer Amplifiers (and Receiver Amplifiers) no longer offer the ability to connect a separate Equalizer like the older models. The current models no longer provide Input / Output ports for Equalizers.

Q: 2. Does the FA 125.2 have tone controls?

A: The Ashly FA-125.2 2-Channel Installation Amplifier does not feature EQ or tone controls.

Q: 3. Is this amplifier CE certified?

A: The Ashly TRA-4150 is Not only CE certified but Safety/Compliance: TUV, FCC, and RoHS.

Q: 4. i want to run 2 pair of bose 701's and need 2 sub outputs. is this the rec to buy??

A: No, you will be able to drive just one pair of the 701s with this amp, and there are no sub outs.

Q: 5. Is it better than the DBX drive rack?

A: Both the Ashly and DBX units are solid products and share many similar features. Your application would determine which product is correct for you. Please feel free to contact a Representative here at 800-606-6969 or email audio@a href= http://bandh.com target= _blank bandh.com/a for information and assistance.

Q: 6. Do these power supplies come with a plug-in AC cord? Rhe spec says 3 wire input with strain relief?

A: No. They are designed to be connected directly to the breaker panel.

Q: 7. Is this the correct picture for the SA120A? It does not appear to be rack-mountable as mentioned in the description.

A: The current model shipping will be the Servo 120a. This unit has rack ears built in where the 120 had them included in the packaging. Our web team is aware of this and the product page should be updated shortly.

Q: 8. usually, you can bridge any amp to use in a mono setting. Can you run this mono?

A: This amp is designed to be used as a stereo amp. It doesn't have any options for bridging.

Q: 9. Does the Ashly ne8250PE amp come with all the Euroblock connectors or do they have to be purchased seperately?

A: The Euroblock inputs are embedded into the rear chassis of the component. No Euroblock connectors ae included as separate DIY items for crimping/soldering onto your own wiring.

Q: 10. any video tutorial for this unit (other then thai ) ?

A: Unfortunately there seem to be no videos featuring this unit. For more information please contact a Sales Representative here at 800-606-6969 or contact Ashly at a href= http://ashly.com/contact target= _blank http://ashly.com/contact/a

anyonymous	25/09/2024
This receiver produces beautiful, clear sound. The electronics are flexible and easy to use, from radio tuner, to iPod, to satellite radio, to phono, and more. 5

Robert F	24/09/2024
Solid amp with XLR inputs. High quality. Integrates nicely with Pre-amp 5

Gary	18/09/2024
This was a direct replacement for one that was 5 years old and didn't survive a bad thunderstorm. Install took no time at all and now it's out of sight, out of mind - the way it should be. Delivery was very quick as well so our downtime was ultimately not bad at all. 5

Brandon	08/09/2024
Excellent. Exactly what I ordered and delivered quickly. Will buy again on this site 5

Christopher	21/08/2024
Purchased to replace a dead 8-channel power supply (also had a few power bricks to eliminate on that setup.) Does exactly what I needed it to do: provide power to 16 analog cameras. The individually-fused outputs are a nice touch, as (now) one shorted camera won't take out the entire surveillance system. 5

Csmith	17/08/2024
This amp is only a two channel amp, but it delivers... 5

Vette	16/08/2024
Excellent build and quality. As expected from a Marantz product. 5

Stephen	16/08/2024
My center channel and two tower speakers were starved for power before this. Now there is more than enough power and the sound coming from center and front speakers sounds great 5

Isaac	15/08/2024
I've amassed a nice little collection of headphones at this point and this is the perfect partner to use most of them with my MOTU M4. It's ridiculously powerful, and even cranked completely up I really don't hear any kind of noise. 5

Mark	07/07/2024
The Marantz mm7025 Power Amplifier has tremendous reserve power for my power hungry 4 ohm Elac Uni-Uni tower speakers. The music comes out unrestrained with excellent pacing, articulate details and sweet tube like tone. Bravo Marantz! You hit this one out of the park with this amplifier! 5