Enhance protection for your camera equipment in cold conditions with the Porta Brace POL-CAR3LINER, a Polar insert designed specifically for the CAR-3CAM camera case. Made of insulated Mylar fabric, this insert prevents heat from escaping your case while keeping the cold out. It is easily removable for scenarios where you need to use the case in its original configuration.

Fits in CAR-3CAM Camera Case    Insulated Mylar Fabric    Keeps Heat In and Cold Out    Easily Removable

Related Questions and Answers

Q: 1. What is the carrying capacity in weight of this case?

A: I contacted the manufacturer concerning your inquiry. According to PortaBrace, the PortaBrace 2500E Hard Utility Case without Insert (Blue) does not have a listed maximum load capacity. That being said, the case will support at least 50 lbs.

Q: 2. Woul this case fit the Lupo Superpanel 60?

A: No, the following unit will not fit the Lupo Superpanel 60.

Q: 3. Its come with one or two dividers?

A: The Tenba Car Case CC17 - for 2 Monolights with Reflectors includes one divider. If you need an additional divider, the Tenba Transport Car Case Divider for 634-402 Car Case CC17 is an option: https://bhpho.to/2QsgNuQ.

Q: 4. Would this fit a Mola Demi beauty dish?

A: Yes and no, the Tenba Car Case CC22 for 22" Reflector may fit the Mola Demi 22" "Beauty Dish", but only if the speed ring is not attached. The attached speed ring increases the depth, not allowing the bag to close properly.

Q: 5. Will this case fit the ASUS G834JYR-XS97 18" with dimensions of 15.71 x 11.57 x 1.21"? I am concerned about the interior 1.21”

A: The PortaBrace PB-2650LSO Laptop Sleeve Insert for the PB-2650 Hard Case is not a case by itself; it is a sleeve insert for a Pelican 1560 Series hard case. It will only fit laptops up to 17".

Q: 6. Will this fit nicely in a nanuk 935 case?

A: The PB-2550LSO has not been tested specifically with the Nanuk 935 case to our knowledge, so the results may vary.

Q: 7. Would this be ok to fly with?

A: I wouldn't fly with it, IMO it's not suitable for flying, only driving (hence the name). I suppose you could fly with it but it wouldn't hold up very long and I'd be concerned about the gear.

Q: 8. Will this fit the Godox BDR-W55 White Beauty Dish 54cm (Bowens Mount)? Dimensions are : 21.3" / : 54.1 cm

A: Yes. The following system will fit inside the case with dish.

Q: 9. I see people are using this with vortex 8, do you need to remove the yoke for it to fit?

A: If you are referring to the Creamsource Vortex8 2x1 RGBW LED Light, then yes, you would need to remove the yoke on the Creamsource Vortex8 2x1 RGBW LED Light Fixture in order to fit it inside the Tenba Car Case for ARRI S60 SkyPanel. The width of the Creamsource Vortex8 2x1 RGBW LED Light without the yoke is 27.2 inches (690mm), while the width with the yoke is 32.7 inches (831mm). The interior of the Tenba Car Case for ARRI S60 SkyPanel is only 31.9 inches (810mm) wide, so the yoke would need to be removed to fit the fixture inside the case.

Q: 10. will this fit the mola demi?

A: As long as the depth of the Mola Demi is not more than 9 inches, it will fit.