The Kupo Midi-Max Baby Kit Stand is a robust 4-section stand made of chrome-plated steel and is a widely versatile tool for mounting fixtures both in the studio and on location. The stand extends to 11.5' via three risers, the top of which carries a directly-welded 5/8" baby pin.

Chrome-Plated Steel 4-Section Stand    Welded 5/8" Baby Pin    28.7 lb Payload    3.2 to 11.5' Height Adjustment    Optional Casters Supported

The Kupo Midi-Max Baby Kit Stand is a robust 4-section stand made of chrome-plated steel and is a widely versatile tool for mounting fixtures both in the studio and on location. The stand extends to 11.5' via three risers, the top of which carries a directly-welded 5/8" baby pin.

This kit stand makes an appropriate support system for mid-sized light fixtures and other equipment. Its triple-riser, 4-section design reflects the standard kit stand platform, but its steel construction allows it to hold up to 28.7 lb of gear on its integrated 5/8" spigot. Its strength does not compromise its portability, however, as its legs quickly fold for transport. For simplified positioning on flat surfaces, Kupo offers a set of optional casters (available separately).

Related Questions and Answers

Q: 1. Can I use a grip head/grip arm on this stand to hold bounces/flags instead of using a C stand?

A: Yes this Kupo Baby Kit Stand can accept a grip head on top.

Q: 2. What is the attached pin used for?

A: The pin attached to the top of the Kupo Baby Stand Extension (6") is designed to connect a light fixture that has a standard 5/8" receiver on the yoke or on the base of the light fixture. It will also support any other lighting equipment that has a 5/8" receiver and uses the standard 5/8" stud.

Q: 3. The base seems pretty small and low on this stand. Would it be a problem to use a 60" octabox on it?

A: This stand can hold to 22 lbs, so if the light you're using along with the 60" octabox is below that load capacity, you would be good to go.

Q: 4. What is the weight of the Kupo KS140611?

A: It weights about 7 lbs.

Q: 5. are 2 of these sturdy enough for a slider? Looking to use it with a Glidegear dev4 and sony fs5.

A: Yes, would make a perfect combo to the Glidegear dev 4 unit.

Q: 6. Are the square legs 22mm and do the Kupo KS940422 80mm Brake Casters fit them? (Same question was not answered before.)

A: No; this stand does not accept casters. The Baby Kit Stand-Black, #KS140511 will accept caster set #KS940322.

Q: 7. Does the center riser drop down down on this model like the round leg version?

A: Hi Rocky, The knobs do allow you to drop the riser down.

Q: 8. What is the minimum height with none of the risers extended?

A: 87cm (34.3 )

Q: 9. Is this compatible with the ringlight below?: Godox LR160 Bi-Color Ringlight (Black)

A: Yes. The following will accommodate the ring light.

Q: 10. Is this stand comptible with the Kupo 80mm Brake Caster 22mm Round? Does it have the notch for the plate to fit?

A: Yes, the Kupo 80mm Brake Caster 22mm Round fit on to the Kupo Midi Baby Kit Stand (10.3'), https://bhpho.to/3EJneBW