Power you CineShooter or Second Shooter motion control system from Gold mount or V-mount batteries with this Regulated D-Tap to 2-Pin LEMO Cable from Kessler Crane. The cable plugs into the D-Tap port of Gold mount and V-mount batteries, or any D-Tap power source that outputs 14.4 to 14.8 VDC, and it regulates the power down to 11.8 to 12.9 VDC to power your compatible Kessler motion control system.

12 VDC Nominal Output    For CineShooter and Second Shooter

Related Questions and Answers

Q: 1. THIS TIRE IS 6" DIAMETER, WHAT IS THE WIDTH?

A: The dimensions of the Kessler Crane 6" All-Terrain Wheels for K-Pod are 8.5"x6"x3".

Q: 2. Will this work with the Sony FX9?

A: Not that we are aware of. However Wooden Camera offers a D-Tap Power Cable for Sony FX9, BH #WO276100. https://bhpho.to/2w5BKpM

Q: 3. Does this come with the 100mm bowl?

A: Yes it does.

Q: 4. What are the dimensions when closed with the wheels attached? Looks amazing but might be too bulky and wide/thick

A: The Kessler Crane K-Pod Tripod System has a Folded Dimension of 39" x 10.75" x 10" and weight is 22lbs. With dolly attached it would add about 5 inches.

Q: 5. I have a Panasonic eva1 with external or reg. monitor it comes with, can the power the external monitor if I need to with one side going into the monitor the other into the Core SWX NANO-VBR98 which I have?

A: It will not. This is a cable specifically to power the EVA1 itself from a V-Mount or Gold Mount Battery with a D-Tap Accessory Port.

Q: 6. can this Jib handle a Sony FS7?

A: This Jib is awesome but it is best used with a body with a short base as the attachment plate for the Jib is a little bit short. There is a possibility that your threaded hole is in a position that it would clear the arm when going up and down but I am not sure. We use it with our Panasonic AC90 and it just clears it. Use strong sticks though as the jib / tripod will wobble if the camera is too heavy. I hope this helps.

Q: 7. will the bottom of this plate sit flat on the table ?? with the plate attached to the camera ?

A: No, it will not. It has two screw heads protruding. They serve as catches so the plate does not slide out of the head.

Q: 8. What would you need to mount the ronin M in the upright position onto this?

A: You can hang the Ronin by attaching the CineMilled DJI Ronin M Quick Plate to the bottom of the crane's camera mounting plate.

Q: 9. Dc barrel connector 5.5 3.3

A: The exact size of this is not listed as it is specifically for the EVA1, FS7 and FS5 cameras.

Q: 10. I lost my pan handle, how can I get a replacement?

A: Please contact Kessler parts department Sales , Support, Parts: (574) 400-2251