The white Rip-Tie 1/2" x 75' WrapStrap is a 75' roll of reusable cable wrap for convenient and secure cable management. It has has been successfully tested for a minimum of 200 release cycles to ensure reliable use over and over again. It is 0.5" in width and features hook-and-loop closure, and it can be cut in length as needed. Utilizing laminating technology to prevent the connecting part from coming off, the WrapStrap can be used for virtually all cables and wires with confidence.

Reusable Cable Wrap for Cable Management    75' Roll    Tested for Minimum of 200 Release Cycles    Hook-and-Loop Fastener

The hard side of the WrapStrap is called a molded hook.

The soft side of the WrapStrap is called a soft-knitted loop.

Laminating hook-and-loop technology is patented worldwide. Many budget alternatives are heat-bonded or united by using adhesive, yielding a connecting part that seems to come off easily. WrapStrap does not come off from the connecting part.

Related Questions and Answers

Q: 1. I have a Pocketalker & need a better mic. This was rec. on the Talker site @ B&H. Any experience out there?

A: We have not tested it specifically with a Williams Pocketalker, but it should be an improvement.

Q: 2. Will this work with the Sachtler FSB 8 Mk II head?

A: No, the Sachtler Tie-Down for flowtech 100 will only work with 100mm heads. The correct tiedown is listed below. Sachtler 75mm Tie-Down Knob for FSB 75 and FSB 75 MKII Heads BH #SA75TD

Q: 3. Will this work with a 2.5mm diameter cable?

A: The exact diameter of this clip is not listed, this clip was design for Sennheiser MKE 2, MKE 102, MKE 104, or MKE Platinum series lavalier microphones.

Q: 4. Can this microphone be used with a Nikon D5000 or a Canon Rebel T3?

A: I have several Nikon cameras with mic sockets and it works with all of them.

Q: 5. Hi. Will this work with the old FSB-8? Thanks

A: Yes, This Sachtler 75mm Tie-Down Knob would work with older Sachtler 75mm heads like the FSB8.

Q: 6. Would this also work with the Sennheiser ME2 mic? a href= http://www.bhphotovideo.com/c/product/217474-REG/Sennheiser_ME2_ME2_Lavalier_Mic_for.html target= _blank http://www.bhphotovideo.com/c/product/217474-REG/Sennheiser_ME2_ME2_Lavalier_Mic_for.html/a

A: It is not recommended for the ME-2 lavalier mice. Try this one - it is a better fit: WindTech TC-12 Dual Lavalier / Lapel Microphone Soft-Mount Tie Clips for 1 - 2mm Microphone Cable (2-Pack, Black) B&H # WITC12

Q: 7. The plastic pieces look gray on the picture. Are they really gray? Not black?

A: The Sennheiser MZQ 22 Double Tie Clip would be in the color black.

Q: 8. Will this work with the Sachtler FSB 10 head? Thanks!

A: Yes, the Sachtler Tie-Down for flowtech 100 Tripod can tie down the Sachtler FSB 10 Mark II Fluid Head with Sideload Mechanism (100mm).

Q: 9. I'm assuming these are fairly standard but would this work on a DV4 ii head? Seems like it has just a standard 3/8 Bolt

A: Yes, The Sachtler DV4 is a 75mm head and would work with the Sachtler 75mm Tie-Down Knob BH #SA75TD.

Q: 10. Why two microphones on the same clip? Is this redundancy in case of failure? Stereo? Something else? Newbie looking to learn.

A: The Sennheiser MZQ 22 Double Tie Clip can be used for mounting either one or two lavalier microphones. The included mic holders that come with the clip are removable. There are a variety of reasons for using two microphones which could be for backup in case one mic fails or for stereo audio, or two mics can send separate audio feeds to two different destinations like two separate mixers, cameras, recorders, etc., or a combination of two devices which could be required for different applications. There is no set rule for how two lavalier mics can be used, but a double tie clip like the MZQ 22 is a very handy tool that will give you the option if the need for two microphones should arise.