The 6’ Lemo FMW to Duplex ST Fiber Inline Breakout Cable from Camplex is an internal distribution breakout cable. It is a pre-terminated SMPTE hybrid breakout cable with a LEMO 3K.93C connector feeding out to duplex ST optical connectors. This breakout series cable is UPC machine polished to meet all SMPTE 304M/311M standards.

The cable is standardized by SMPTE for HDTV Broadcast camera use. It consists of two single-mode optical fibers with ST connectors. This general purpose cable is used for studios and light to medium field use. A flexible PVC blend jacket allows for ease of use within the studio.

Assembled with SMPTE cable & LEMO and Senko connectors

Industry standard cable

Terminations by LEMO trained technicians

Fiber optic assemblies 100% tested for attenuation and back reflection

SMPTE 311M and 304M compliant

Stainless steel assemblies

Rubber dust caps

19.4 Mb/s to 3 Gb/s transport rate

Machine polished fiber contacts

Low insertion and return loss

Related Questions and Answers

Q: 1. What is the video latency ?

A: Good Morning Marcelo. our CMX-HDMI-TR set is considered zero latency. Thank you!

Q: 2. Does this work with Teradek Bolt?

A: The 2-pin LEMO works, but it's all contingent on where you are connecting it to and making sure that proper voltage is being sent through to avoid damage.

Q: 3. What is the diameter of the upper leg section?

A: The diameter of the upper leg section of the Sirui ST-224 Waterproof Carbon-Fiber Tripod is 29.4mm.

Q: 4. Is this available with a right angle Lemo connector?

A: Hello Frank C, unfortunately this is only a straight connector and it is not a LEMO connector, it is a proprietary Atomos Connector.

Q: 5. How long are this cable?

A: Hello AL P, it is just about half a foot from tip to tip.

Q: 6. Is this cable shielded?

A: The Tilta 2-Pin to 2-Pin LEMO Cable (23") is shielded.

Q: 7. Can anyone confirm what TYPE this 10-pin Lemo connector is: the 1B or the 2B? Atomos' website/manual gives no specs. Thanks

A: Hello JIm K, they are Atomos Spec, this is NOT a Lemo or made by LEMO. it only works with our products. thank you.

Q: 8. Can I use a LEMO extension cable to that the XLR connectors are not dangling off the side of the Atomos?

A: We are not aware of LEMO Extenders for the Atomos break out cables.

Q: 9. Does Atomos or anyone make a 90 degree version of this cable?

A: Hello Jason P, unfortunately we do not no.

Q: 10. So when you get this xlr breakout cable and connect it to a atomos ninja flame you still get the quality of xlr microphone ? since the ninja flame just the have the xlr input?

A: Hello Shopper, the Lemo type connector is only for the Shogun units such as the Shogun, Shogun Flame and soon to be Shogun Inferno. The Ninja Flame uses a 3.5mm audio jack.